Ribbon

SYMPTOM

POSSIBLE CAUSE

REMEDY

REMARKS

Load lever will

not latch.

1. Ribbon lift guides binding

on card holder.

Adjust card holder to rear for

clearance with ribbon lift (105-13)

2. Load lever spring missing

broken or damaged.

(107-33).

Replace

3. Load lever detent broken,

missing or damaged.

Replace or remove binds in detent

(111-39) for load lever.

Machine will not

go in stencil

position.

1. Stencil lever broken or

binding (104-5).

Replace

2. Stencil lever lug not pre

venting ribbon drive.

Stencil lever lug should prevent

the cam follower from following

the contour of the ribbon cam

(106-18)

3. Stencil lever not trans

ferring lift control link

to rear of lift cam follower/.

Adjust lift control link (105-16) to

move all the way to rear of cam

follower when in stencil position.