Selectric Resources

 

MARGIN BACK AND RAIL REMOVAL (DUAL PITCH)

 

1. Remove the margin rack gear toggle spring and gear guard.

2. Loosen the margin pitch link guide bracket.

3. Disconnect the margin release bracket spring.

4. Loosen the margin release bracket screws and slide the margin release bracket to the rear.

5. Disengage the margin sliders by holding the margin set levers to the rear. Slide the margin rack out of the machine. Note the position of the margin rack spring, washer and bushing.

6. Lift the margin rail out of the machine.

7. Remove the margin rack gear if necessary.

8. The following adjustments should be checked after the margin rack and rail are replaced.

 

a. Margin pitch link guide bracket

b. Margin rack gear

c. Front margin rack gear stop