Selectric Resources

 

COVER REMOVAL

 

Levels 1 And 2

1. Position the carrier near the center.

2. Move the margin stops away from the carrier.

3. Tip the machine on its back.

4. If Level 1 cover, loosen cover screw at center rear.

5. Push rear of cover straight away from machine.

6. a. If Level 1 cover, lift bottom cover vertically to free front brackets.

b. If Level 2 cover, push front of bottom cover straight away from machine.

7. Remove the power cord from the rear vent grille.

8. Loosen the four mounting screws that hold the mounting plates to the center cover.

9. Set the machine on its feet, then pivot the locking plates from below the mounting screws.

10. Pull the paper release lever and paper bail forward.

11. If the machine is equipped with a paper table, pivot the paper table to the rear.

12. Raise the top cover and remove the platen by releasing the latch at each end.

13. Latch both margin levers and the red pointer up.

14. Remove the top and center cover by lifting straight up.

15. Install platen.

 

Level 3

1. Position the carrier near the center.

2. Move the margin stops away from the carrier.

3. Pull the paper release lever and the paper bail forward.

4. Raise the top cover and pivot the paper table to the rear.

5. Remove the platen by releasing the latch at each end.

6. Pull the cover release levers (inside center cover section) forward.

7. Latch both margin levers and the red pointer up.

8. Lift the top and center cover straight up.

9. Remove the plastic vent grille by lifting straight up.

10. Reinstall platen.

11. Pull bottom cover release lever forward.

12. Machine may now be tilted up within the bottom cover.